Epson DFX-9000 - Page 154

Epson DFX 9000 Revision B
Disassembly and Assembly Safety switches 147
CO SW ASY
1. Remove the UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar. Refer to section 4.2.4.1 PR MECHA ASY, p. 149.
3. Release the CO SW ASY cable from the three clamps (SIDE
FRAME, RIGHT: 2 places; bottom rear: 1 place).
4. Disconnect the CO SW ASY cable from the SENSOR BOARD
UNIT (CNCOS: 2 pins), and pull the CO SW ASY cable out through
the hole in the SIDE FRAME, RIGHT.
5. Release the front tab of the CO SW ASY from the inside of the PR
MECHA ASY, and slide the CO SW ASY backward. Then release
the rear tab to remove the CO SW ASY. See arrows 5)-1 and 5)-2 in
Figure 4-21.
6. Remove the CO SW ASY from the CO SW HOLDER.
Figure 4-21. CO SW ASY Removal
W A R N I N G
 Disconnect the power cable and wait at least 5 minutes
for capacitors to drain before disassembling the
POWER UNIT. If you touch the POWER UNIT with
the power supplied, you may receive an electric shock.
 Do not touch the motors immediately after using the
printer, or you may burn your hand. Allow the motors
to cool enough to work with them.
C A U T I O N
When performing the following procedures, be careful not
to bend the lever of the CO SW ASY.
CO SW ASY
4)-1
5)-1
5)-2
6)
3)
[Front]
[Rear]
SENSOR BOARD