Epson DFX-9000 - Page 164

Epson DFX 9000 Revision B
Disassembly and Assembly SP MOTOR ASY 157
8. Tilt the rear of the SP MOTOR ASY to the right, and lift the Tension
pulley to remove the SP MOTOR ASY together with the SP BELT.
9. Remove the four C.P. (S-P1) 4 × 10 screws that secure the SP
MOTOR, Motor base, and Motor bracket, and remove the SP
MOTOR.
Figure 4-34. SP MOTOR ASY Removal (3)
Figure 4-35. SP MOTOR ASY Removal (4)
C A U T I O N
When you remove the Tension pulley, be careful not to
lose the washer on the inner shaft. It comes off easily.
A D J U S T M E N T
R E Q U I R E D
Be sure to perform the following adjustments after
replacing the SP MOTOR.
1. CR Drive Belt Tension Adjustment
2. Bi-D Adjustment
8)-1
8)-2
7)
7)
Tension pulley
SP BELT
SP MOTOR ASY
SP BELT
Motor base
Motor bracket
SP MOTOR ASY
9)
9)
9)
9)