Epson DFX-9000 - Page 172

Epson DFX 9000 Revision B
Disassembly and Assembly RF UNIT 165
6. Remove the C.B.S. 3 × 6 screw that secures the RF UNIT to the SIDE
FRAME, RIGHT, and remove the RF UNIT while slowly feeding the
cables through the SIDE FRAME, RIGHT. The connectors on the end
of the cables will fit through the hole one-at-a-time.
Figure 4-44. RF UNIT Removal (2)
Figure 4-45. Reinstalling the RF UNIT
C A U T I O N
When removing or installing the RF UNIT, be careful not
to damage the RF UNIT cables.
When installing the RF UNIT, match the positioning holes
of the RF UNIT with the pins on the inside of the SIDE
FRAME, RIGHT.
6)-1
6)-2
RF UNIT