Epson DFX-9000 - Adjustment; Adjustment Overview; Required Adjustments

Epson DFX 9000 Revision B
Adjustment Adjustment overview 212
5.1 Adjustment overview
5.1.1 Required adjustments
This section describes the adjustments required after certain parts are removed or replaced. Table 5-1 below shows the parts removed or replaced, and
the corresponding adjustments required.
 Numbers in cells show the adjustment order.
 A numbered cell with no shading indicates an adjustment that must be made only if the part is replaced with a new part.
 A yellow-shaded cell indicates an adjustment that is needed if the part is removed and put back, or replaced with a new part.
 “-” in a cell means that the adjustment is not required.