Epson DFX-9000 - Bottom Margin Adjustment

Epson DFX 9000 Revision B
Adjustment Software adjustment 248
5.3.6 Bottom margin adjustment
This procedure adjusts the position of the last line of print on the bottom
edge of the paper. This adjustment is required after you remove or
replace these parts:
 PR MECHA ASSY
 CARRIER UNIT
 ROM BOARD (only when the EEPROM Data Copy fails)
Tools / materials: Adjustment Program
Paper: 1 sheet of 64 g/m
2
(17 lb)
Objective: Normal paper bottom margin:
2.1 ~ 3.1 mm (0.08 ~ 0.12 inch)
Black paper bottom margin:
2.6 ~ 4.6 mm (0.10 ~ 0.18 inch)
Adjustment Procedure
1. Set a single sheet of paper on the tractor, and load it by pressing
[Load].
2. From the Adjustment Program, select Bottom Margin Adjustment.
3. Click Print to print the bottom margin check pattern using the
currently saved parameters.
Figure 5-31. Bottom Margin Adjustment screen