Publishing Discs 29
n Before using or touching the printed surface of your discs, make sure they are completely dry
and keep them out of direct sunlight.
n If the printed surface is sticky even after it has dried, do the following.
1. Change label type.
2. Change color saturation level.
3. Change the disc.
n Moisture on the printable surface may cause smearing.
n If you print on the matte label type of Epson specified CDs, set Label Type to CD/DVD Label.
n If you print on the matte label type of Epson specified DVDs, set Label Type to CD/DVD
Premium Label.
n When using Epson specified discs, only [1] can be selected for Print Mode setting.
n Reprinting on the same disc may not improve the print quality.
n Be sure to clean the inside of the stacker before using it if there is any dirt.
n Please check disc before printing, as the size of the receptor may vary.
n Ink may not bond if printed outside the receptor.
n If the product is operating, wait for 10 seconds after the operation is finished, and then turn
the power off.
n The quality of the blank disc determines print and write/read quality. It is recommended to
use only the specified disc type.
n Do not use a cracked, warped, or deformed disc because it may break in pieces inside the
product and cause malfunction or injury.
n A disc may become unreadable or unwritable if it has a small scratch or dirt; therefore, please
handle it with care.
n Hold disc by the edge, and do not touch either surface.
n The completed job display of EPSON Total Disc Monitor shows the number of successes,
number of failures, and number of discs printed.
n Do not use discs with lens cleaner, a label sticker, or condensation on them as it may cause
mechanical error or malfunction.
n Only for the PP-100III/PP-50II:
To Next Page
Loading...
