-16
R4C4600
html.bk Rev.C
TROUB.FM A5 size
7/24/01
L
Proof Sign-off:
ABE Y. Azuma, Nagasawa
Takahashi
ABE S.Halvorson
Paper on the paper guide is
positioned too far to the left,
right or inside for the paper
sensor to detect it.
Move the paper a little to the right, left
or inside. When it is positioned
properly, the Paper Out and Pause
lights go off.
The printer sounds like it is printing, but nothing prints.
Cause What to do
The ribbon cartridge is not
installed properly.
Reinstall the ribbon cartridge as
described in “Replacing the ribbon
cartridge”.
The ribbon is worn out. Replace the ribbon cartridge as
described in “Replacing the ribbon
cartridge”.
The paper source is not
selected correctly.
Select the desired paper source on the
control panel. See “Buttons and
Lights”.
The printer makes a strange noise and stops abruptly.
Cause What to do
The paper is jammed. Clear the paper jam as described in
“Clearing a Paper Jam”.
The ribbon is jammed
because it has too much slack
or it is worn out.
Remove any slack from the ribbon by
turning the ribbon-tightening knob, or
replace the ribbon cartridge. See
“Replacing the ribbon cartridge”.
To Next Page
Loading...
