34
Chapter 2 Setup
2
3
Connect the cable to DP-110, computer, and TM printer to match the constructed
environment. (See "Connecting" on page 74)
4
Arrange the cables as shown below. Put the cables inside the DP-110.
For the RS-232/USB model, the end of the connector of the unused cable should be
capped, and then bundled to be stored inside DP-110.
5
Attach the base plate to the DP-110 following the numbered arrows shown below.
Then push the base plate until it is locked by the hook on the DP-110.
6
When the extension support (DP-105) is used, attach affixing tapes to the four
corners of the plate to keep the unit from falling down.
7
When using the AC adapter, insert the power cord to the AC adapter, and then insert
the power cord to the outlet.
The plate is locked
by the hook.
To Next Page
Loading...
