60
Chapter 2 Setup
2
Installing to the TM-J7200/TM-J7700
1
Pass the cable for this product through support C and attach support C to this
product. When using support B for extension, insert the tab on support B into the
hole on support C until you feel it click.
2
Pass the RS-232 cable for this product through the hole on fixing plate A.
Do not pass the USB cable through fixing plate A as it is later stored in support C.
• The illustrations used here are for DM-D110, but you can still use them as your reference for
DM-D210.
• Because the illustration used here is for the RS-232/USB model, there are 2 cables. The USB
model and RS-232 model have 1 cable.
When using support
B for extension
To Next Page
Loading...
