Installation Guide
9
Installation Work Flow
Follow the procedures below to mount the projector on a wall.
a
Installing the Setting Plate and the Projector (s p.27)
b
Adjusting the Projected Image (s p.40)
c
Calibrating the Interactive Pen (s p.47)
d
Installing the Control Pad (s p.53)
When installing the Touch Unit, finish installing the projector first, and then follow the procedures below
(EB-1430Wi only).
a
Installing the Touch Unit (s p.56)
b
Adjusting the Angle of Laser Diffusion (s p.60)
c
Performing Touch Calibration (s p.71)
To Next Page
Loading...
