Installation Guide
11
Control Pad
The following supplied products are necessary when attaching the Control Pad. Confirm that you have all
items before beginning.
AA size batteries
(x2)
Rubber feet Port protection
stickers
Control Pad main unit
When installing the Control Pad on a wall and so on, prepare commercially available M4 screws (20 mm x4).
Touch Unit (EB-1430Wi only)
The following supplied products are necessary when attaching the Touch Unit. Confirm that you have all
items before beginning.
Touch Unit/Markers x2 (attached to Touch Unit) Touch Unit connection cable
Spacer for screw hole x3 Label x4 Tape (approx. 6 cm) for secur‐
ing the marker x12
Infrared deflector
(approx. 28.5 cm) x8
When installing the Touch Unit on a non-magnetic surface, prepare three M4 screws.
To Next Page
Loading...
