Installation Guide
33
b
Attach the template sheet to the wall
•
Match the center line ( ) checked in step 1 to the Image Center line on the template sheet.
Confirm where the beams are within the wall, and shift the position left or right as necessary.
(The position can be shifted horizontally left or right from the center line of the projection surface up to a
maximum of 45 mm.)
•
Match the height ( ) checked in step 1 to the line on the template sheet.
[Unit: mm]
c
Determine the positions for the mounting holes for the wall plate
Secure the wall plate in at least three points.
•
If securing the wall plate in four places, make the holes indicated by A or B in the figure.
•
If securing the wall plate in three places, make the holes indicated by C in the figure.
Four mounting holes Three mounting holes
To Next Page
Loading...
