Installation Guide
40
e
Connect the cables to the projector
Attach the Wireless LAN unit supplied to the wireless LAN unit's installation section.
c
•
Connect the power cord last.
•
When connecting to the Audio1, Audio Out, and Computer ports, we recommend connecting cables
to the ports in the following order: Audio1, Audio Out, and then Computer.
Adjusting the Projected Image
Follow the procedures below to adjust the projected image.
a
Adjusting the Projection Position (s p.40)
b
Fine-tuning the Focus (s p.46)
c
Calibrating the Pen (s p.47)
Adjusting the Projection Position
•
Do not make adjustments using the projector's Keystone function. Doing so may result in a reduction in image quality.
•
When setting up multiple projectors using the batch setup function, perform this procedure before adjusting the
projected image.
s "Batch Setup Function" p.75
To Next Page
Loading...
