Appendix
108
Batch Setup Function
After making the projector's menu settings for one projector, you can copy the settings to other projectors
(batch setup function). The batch setup function is only for projectors with the same model number.
Use one of the following methods.
•
Setup using a USB flash drive.
•
Setup using EasyMP Network Updater.
This guide explains the USB flash drive method.
c
•
The following menu settings are not copied by the batch setup function.
•
Network menu settings (except for the Notifications menu and the Others menu)
•
Lamp Hours and Status from the Info menu
•
Perform batch setup before adjusting the position of the projectors. Adjustment values for the
projected image, such as Keystone, are copied by the batch setup function. If batch setup is performed
after adjusting the position of the projectors, the adjustments you made may change.
•
By using the batch setup function, the registered User's Logo is copied to the other projectors. Do not
register confidential information and so on as the User's Logo.
Caution
Performing batch setup is the customers responsibility. If batch setup fails due to a power failure,
communication error, and so on, the customer is responsible for any repair costs incurred.
To Next Page
Loading...
