Installation Guide
67
h
Install the installation plate using three M4 commercially available 4 mm wood screws, or
three M4 anchor bolts.
i
Attach the securing plate to the rear of the Touch Unit with the two M4 x 25 mm bolts
supplied
Adjust the position so that the two screw holes of the Touch Unit and the two screw holes of the
securing plate are aligned. Tighten the bolts to the securing plate using the supplied hexagon wrench.
Caution
There is a powerful magnet on the rear of the Touch Unit. Do not trap your hand between the Touch
Unit and the securing plate.
To Next Page
Loading...
