Installation Guide
69
m
Secure the Touch Unit and the installation plate with the hexagon socket head cap bolt
The bolt used varies according to the distance (f) from the wall to the surface of the screen measured
in step 11. Tighten the bolt to the installation plate using the supplied hexagon wrench.
When (f) = 20 to 35 mm: M4 x 55 mm bolt
When (f) = 35 to 50 mm: M4 x 70 mm bolt
n
Connect the Touch Unit connection cable that is connected to the projector to the TCH
port on the Touch Unit
Angle Adjustment
An infrared laser in the shape of a curtain is emitted from the Touch Unit. The infrared laser reflects off your
finger when touched to the whiteboard thereby detecting the finger position allowing the projector's infrared
camera to recognize the position being reflected.
To Next Page
Loading...
