Adjusting the Interactive Pen
88
e
Repeat step 4 until all of the dots disappear
The dot appears at the top left first and then moves towards the bottom right.
When all of the dots disappear, Manual Calibration is complete.
c
Check that there are no obstacles between the interactive pen and the Interactive pen
receiver (shown below).
If you touch the wrong position, press the [Esc] button on the remote control to return to the
previous dot.
To cancel calibration, hold down the [Esc] button for two seconds.
Auto Calibration
a
Turn on the projector, and then press the [Menu] button
Using the Remote Control Using the Control Panel
To Next Page
Loading...
