Installing the Touch Unit
114
i
If only one projector is installed, touch ( ) displayed on the screen with your finger and
check if (
) is displayed in the same position
Touch all four ( ) to confirm.
Screen Status
Adjustment has been performed correctly if the lo‐
cation you touch with your finger is the same place
as where (
) is displayed.
If ( ) is displayed in a different location to the
point you touched, select Up once using the control
panel or the remote control. Next, touch (
)
again with your finger to confirm.
Repeat until (
) is displayed in the correct posi‐
tion.
Adjustment is complete when ( ) appears in the correct position for all four ( ) positions.
Go to "Calibrating the touch operation position" p.119.
j
When multiple projectors are installed, on the next projector, select Installation > Touch
Unit > Touch Unit Adjustment Guide
The following screen is displayed on the next projector.
To Next Page
Loading...
