Epson EB-1485Fi - Adjusting Using the Projector Menus

Installing the Wall mount
64
h
Loosen the M6 bolt, and then adjust the vertical slide
i
Re-tighten the screws and bolts that you loosened in steps 3 to 8
Warning
Tighten all bolts and screws firmly. Otherwise, the product may fall and cause personal injury or
property damage.
j
Adjust the focus of position A in the following figure
k
When you have finished making adjustments, press the [Esc] button on the remote control
or the control panel to exit the guidance screen
Adjusting using the projector menus
c

You can save adjusted values in Memory from the Geometry Correction menu.

Before performing the adjustment, set the Screen Type setting first. If you change the Screen Type after
making corrections, the corrections will be reset.