ELPIU03
Interactive Unit
Quick Setup Guide
Included Items
Interactive Unit
M4 x 10 mm hexagon socket head cap bolt
with washer and spring washer
(x1)
Epson Projector Software for
Easy Interactive Function CD
Easy Interactive Pen (x2)
AAA batteries (x4)
Pen tray
M4 hexagonal wrench
Document CD-ROM
Quick Setup Guide (this guide)
USB cable
Installing the Interactive Unit
Before attaching the Interactive Unit to the projector, install the ELPMB27 wall mount. See the
Installation
Manual
supplied with ELPMB27, and complete all steps up to step 8.
Warning:
Attachment to the projector should be performed by quali ed technicians using only approved mounting •
equipment.
Follow the steps below to attach this product. Incomplete or incorrect installation could cause the •
product to fall and cause personal injury or property damage.
M3 x 8 mm cross-head screw
(x1)
Insert the Interactive Unit into the ELPMB27 attachment plate.
a
Use the M4 x 10 mm bolt with washer and spring washer to secure the Interactive Unit.
b
Remove the USB cover, and then connect the USB cable.
c
Attach the USB cover, and then secure it using the M3 x 8 mm cross-head screw.
d
Adjust the length of the USB cable.
e
Next, go to step 9 in the ELPMB27
Installation Manual
and install the ELPMB27 arm cover, adjust the screen
position, then install the interface cover bracket and covers.
This product is an Interactive Unit for EB-435W/EB-430/EB-425W/EB-420/PowerLite 435W/PowerLite 430/
PowerLite 425W/PowerLite 420.
You can attach and use this product with a projector that has been mounted on a wall or hung from a ceiling.
This book explains how to mount the Interactive Unit when the projector is mounted on a wall using the wall
mount (ELPMB27). When hanging from a ceiling, see also the
Installation Guide
supplied with the attachment
plate (ELPPT04).
Prepare other tools as necessary.
To Next Page
Need help?
General
