Installation Guide
27
External speakers
Audio cable (commercially available)
Microphone (commer‐
cially available)
LAN device
LAN cable (commercially
available)
Installation Procedure
Make sure to follow the steps below to install the setting plate. If these steps are not followed, the product
could fall and cause personal injury or property damage.
Warning
Do not use adhesives, lubricants, or oils to install or adjust the setting plate. If you use adhesives to prevent
the screws from loosening or things such as lubricants or oils on the slide plate fixing part of the projector,
the case may crack and cause the projector to fall, resulting in personal injury or property damage.
Disassemble the parts
Remove the M4 bolts (x2), and then remove the slide plate from the 3-axis adjustment unit.
Assemble the parts
a
Assemble the three wall plates into one unit, and secure them with the M4 bolts (x6)
supplied
To Next Page
Loading...
