Appendix
60
c
While holding down the [Menu] button on the remote control or the control panel, connect
the power cord to the projector
The status indicator and the power indicator turn blue, and the lamp indicator and the temperature
indicator turn orange.
When all of the projector's indicators turn on, release the [Menu] button. The indicators turn on for
approximately 75 seconds.
When all of the indicators start flashing, the settings are being written.
Caution
•
Do not disconnect the power cord from the projector while the settings are being written. If the power
cord is disconnected, the projector may not start correctly.
•
Do not disconnect the USB flash drive from the projector while the settings are being written. If the
USB flash drive is disconnected, the projector may not start correctly.
When writing completes normally, the projector turns off, and only the power indicator is lit blue.
When the power turns off, remove the USB flash drive.
To Next Page
Loading...
