Introduction
10
Part Name Application
M3 x 6 mm cross recessed
head shoulder screws (x4)
Secure the mini PC plate to the wall
plate.
Touch Unit
Part Name Application
Touch Unit -
Template sheet (for secur-
ing the Touch Unit)
Attach this to the wall before attaching
the Touch Unit, and use it to drill nec-
essary holes.
Touch Unit connection ca-
ble (approx. 1.8m)
Connect the Touch Unit to the projec-
tor.
Markers x2 Attach to the screen to adjust the angle
of the laser emitted by the Touch Unit.
c
When the finger touch op-
erations do not work cor-
rectly, you need to use the
markers again to re-cali-
brate the angle of the laser.
Keep these in a safe place
after installing.
Tape for securing the mark-
ers
(approx. 6 cm) x12
Secure the markers to the projection
surface.
Infrared deflectors
(approx. 28.5 cm) x12
Use these when there is a tray or frame
at the bottom of the projection surface.
This prevents malfunctions due to laser
reflections.
Spacers for screw holes x3 Attach them to the screw hole when
securing the Touch Unit with screws.
Label x4 Attach the label in the position of the
Touch Unit. These provide markers
when repositioning due to movement
that occurs during use.
To Next Page
Loading...
