Introduction
15
When you want to use the installed Touch Unit (older model) as it is, leave a gap of 25 to 100 mm between
the bottom of the Touch Unit and the top of the image. You may need to re-install the Touch Unit to project
at a different size or aspect ratio.
When Installing Multiple Projectors Nearby
If interactive pen operations do not perform correctly between projectors installed nearby, connect the
projectors by using a commercially available stereo mini jack cable (ø3.5mm, no resistance).
After connecting the cable, set Installation of Projectors - Sync of Projectors to Wired from the Pen/
Touch menu to stabilize the interactive pen operations.
To Next Page
Loading...
