Installing the Wall mount
49
f
Place the wall plate on the temporary M10 screw that you installed in step 2
g
Use commercially available M10 or 3/8 inch x 60 mm anchor bolts to secure the wall plate
to the holes you drilled in step 4
Attaching the setting plate to the wall plate
a
Loosen the M4 x 12 mm bolts (x2) and extend the arm slide on the setting plate
Adjust the scale on the slider to the combined distance of the value for (b) confirmed in the projection
distance table ( p.30) and the thickness of the projection surface (x).
To Next Page
Loading...
