Epson EB-770Fi - Adjusting the Position of the Projected Image

Installing the Wall mount
58
Adjusting the Position of the Projected Image
You can use any of the following methods to adjust the position of the projected image.
c
When multiple projectors are installed in the same room, we recommend that you set projector IDs
to prevent remote control interference.
Turn on a projector and set the ID number for the projector in Installation > Projector ID.
(When using EB-770Fi, set from Multi-Projection - Projector ID.)
When you want to operate a specific projector, hold down the [ID] button on the remote control
and press the button with the same number as the projector ID.
•
Auto Screen Adjustment ( p.61)
Attach corner markers (supplied with the projector) to the four corners of the projection position to automatically
adjust the position of the image. This is useful when you want to perform an approximate adjustment to a specific
position.
•
Adjusting using the Setting Plate Installation Guide ( p.65)