b
While holding the [ID] button, press a number button to select a
number to match the ID of the projector you want to operate.
s "Checking the Projector ID" p.28
Remote control
Once this setting has been made, the projector that can be operated by the
remote control is limited.
a
The remote control ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them and so on,
the stored ID setting is retained. However, if the batteries are left out
for a long time, it is reset to the default value (ID0).
Setting the Time
You can set the time for the projector. The set time is used for scheduling
and for wireless LAN authentication.
Press [Menu] button > Extended > Operation > Date & Time
a
• When you turn on the projector for the first time, the message "Do
you want to set the time?" is displayed. When you select Yes, the
following screen displayed.
• When Time/Schedule Protection is set to On in Password
Protection, settings related to the date and time cannot be changed.
You can make changes after setting Time/Schedule Protection to
Off. s p.59
Date & Time
Submenu Function
Date
Set today's date.
Time
Set the current time.
Time Difference (UTC)
Set the time difference from Coordinated
Universal Time.
Set
The settings made in Date & Time are applied.
Daylight Saving Time
Submenu Function
Daylight Saving Time
Set whether or not (On/Off) to activate the
daylight saving time.DST Adjustment (min)
adjusts the time difference between the standard
time and the daylight saving time.
Setting Up
29
To Next Page
Loading...
