Epson EB-G6750WU - Attaching the Cable Cover

a
• Make the following settings to output image and audio even when the projector is in standby mode.
Set Standby Mode to Communication On.
Press [Menu] button > Extended > Standby Mode
Set A/V Output to Always On.
Press [Menu] button > Extended > A/V Settings > A/V Output
• Only analog RGB signals being input to the Computer port or the BNC port can be output to an external monitor.
• When the audio cable jack is inserted into the Audio Out port, audio stops being output from the projector's built-in speakers and switches to external
output.
Connecting a LAN Cable
Connect a LAN port on network hubs or other equipment to the projector's LAN port with a commercially available 100BASE-TX or 10BASE-T LAN
cable.
By connecting a computer to the projector over a network, you can project images and check the status of the projector.
LAN
a
• To prevent malfunctions, use a category 5 or higher shielded LAN cable.
• You need to connect a LAN cable to update software using "EasyMP Network Updater".
Connecting Equipment
39