Connecting an HDBaseT Transmitter (EB-G6750WU Only)
Connect the optional HDBaseT Transmitter with a commercially available 100BASE-TX LAN cable.
HDBaseT
a
• Make sure you read the User's Guide supplied with the HDBaseT transmitter carefully before use. Make sure the HDBaseT transmitter is properly earthed before
use.
• Use a category 5e or category 6 shielded LAN cable.
• When connecting or disconnecting the LAN cable, make sure you turn off the power for the projector and the HDBaseT transmitter.
• When performing Ethernet communication or serial communication, or when using the wired remote control via HDBaseT port, set Control Communications
to On from the Configuration menu.
Press [Menu] button > Extended > HDBaseT > Control Communications
Note that when Control Communications is set to On, the projector's LAN port, RS-232C port, and Remote port are disabled.
Connecting Equipment
40
To Next Page
Loading...
