b
Use the [ ], [ ], [ ], and [ ] buttons to select the corner you
want to adjust, and then press the [
] button.
When selecting a corner, you can adjust the two sides next to the
corner.
c
Use the [ ], [ ], [ ], and [ ] buttons to adjust the shape.
If the triangle in the direction you are adjusting the shape turns gray,
as shown in the screenshot below, you cannot adjust the shape any
further in that direction.
Point Correction
When multiple images overlap, you can fine tune the areas that overlap.
Divides the projected image by the grid and corrects the distortion by
moving the point of intersection from side to side and up and down.
You can also use this to correct small and partial distortions.
Correction range
You can correct in increments of 0.5 pixels up to a maximum of 7 pixels
vertically and 32 pixels horizontally.
Projecting Images
46
To Next Page
Loading...
