Wired LAN
To connect a computer to the projector in a wired LAN environment, you
need to perform network settings on the computer and the projector.
a
Check with your network administrator if DHCP is available on the
network being used.
a
If DHCP is not available, check the following values on the
projector.
• IP address
• Subnet mask
• Gateway address
b
Connect the computer to the network.
a
If it is not connected, make network settings on the computer.
For more details, see the user's guide supplied with the
computer.
c
Connect a LAN cable to the projector.
d
Turn on the projector.
e
Display the Network Configuration screen on the projector.
Press [Menu] button > Network > Network Configuration
f
Select the Wired LAN menu.
The following screen is displayed.
g
Select IP Settings.
When DHCP is available: Set DHCP to On.
When DHCP is not available: Set DHCP to Off, and then enter the
projector's IP address, subnet mask, and gateway address.
h
When you have finished making settings, select Setup
complete.
Network Setup
67
To Next Page
Loading...
