Wired LAN menu
Submenu Function
IP Settings
DHCP: You can set whether or not (On/Off) to use
DHCP
g
.
If this is set to On, you cannot set any more addresses.
IP Address: You can input the
IP Address
g
assigned to the
projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask: You can input the
Subnet Mask
g
for the
projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can input the IP address for the gateway
for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following
Gateway Address
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
IP Address Dis-
play
To prevent the IP address from being displayed, set this to Off.
Mail menu
When this is set, you receive an email notification if a problem or warning
occurs in the projector.
s "Reading error notification mail" p.162
List of Functions
118
To Next Page
Loading...
