Images appear dark
Check Remedy
Is the image brightness set correctly? Check the Brightness and Power Consumption settings from the Configuration menu.
s Image - Brightness p.107
s
Settings - Power Consumption p.110
Is the
Contrast
g
adjusted correctly? Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.107
Is it time to replace the lamp? When the lamp is nearly ready for replacement, the images become darker and the color quality becomes poorer. When
this happens, replace the lamp with a new lamp.
s "Replacing the Lamp" p.148
Is only one projector being used? Check if the following items are set to dark.
s Extended - Multi-Projection - Brightness Level p.112
s Extended - Multi-Projection - Multi-screen p.112
Problems when Projection Starts
The projector does not turn on
Check Remedy
Did you press the [
] button on the remote control or the [
t
]
button on the control panel?
Press the [ ] button on the remote control or the [
t
] button on the control panel to turn on the projector.
Are the indicators switched off? The power cord is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cord.
Check that your electrical outlet or power source is functioning correctly.
Do the indicators turn on and off when the power cord is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this
does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Problem Solving
139
To Next Page
Loading...
