n
Press the [Test Pattern] button on the remote control or the [ ]
button on the control panel to display the test pattern.
o
Adjust the lens balance by turning the adjustment screws with the
ball point hexagonal wrench.
A
Loosen
B
Tighten
When the screws are loosened the focus moves to the rear, and when
the screws are tightened the focus is brought to the front.
The following illustration shows the adjustment screws and their
relative adjustment positions when viewed from the rear of the
projector.
p
Repeat steps 11 to 15 to make further adjustments.
Whenever you make adjustments, adjust the focus with the focus
ring and check the projected image.
q
When you have finished making adjustments, turn off the
projector and remove the projection lens unit.
r
Tighten the locking screws (three points).
Image Maintenance
158
To Next Page
Loading...
