Correction method
a
Press the [Menu] button while projecting.
b
Select Geometric Correction from Settings.
c
Select Corner Wall, and then press the [ ] button.
If the message "If this setting is changed, the image may be
distorted." is displayed, press the [
] button.
d
Select Corner Type, and then press the [ ] button.
e
To fit the projected image to the projection position, select
Horizontal Corner or Vertical Corner, and then press the [
]
button.
When the surfaces line up horizontally:
Select Horizontal Corner.
When the surfaces line up vertically:
Select Vertical Corner.
From here on, steps are explained using Horizontal Corner as an
example.
f
Press the [Esc] button to display the screen from step 4. Select
Correct Shape, and then press the [
] button.
Adjusting Projected Images
68
To Next Page
Loading...
