Epson EB-G7905UNL - Page 168

Indicator Cause Remedy or Status
Power Status Lamp Temp Filter
Blue -
Flashing
Status
varies
Status
varies
Orange -
Flashing
Status
varies
High Temp Warn‐
ing
This is not an error. However, if the temperature rises too high again, projection stops automatically.
Check the following two points.
• Check that the air filter and air exhaust vents are clear, and that the projector is not positioned against a
wall.
• If the air filter is clogged, turn off the power, remove the power cord from the electrical outlet, and then
clean or replace them.
s "Cleaning the Air Filter" p.189
s "Replacing the Air Filter" p.195
Blue -
Flashing
Status
varies
Orange -
Flashing
Status
varies
Status
varies
Replace Lamp Replace it with a new lamp.
s "Replacing the Lamp" p.192
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may
explode increases. Replace it with a new lamp as soon as possible.
Blue - On Status
varies
Orange -
Flashing
Status
varies
Status
varies
Installation posi‐
tion warning (non-
support position,
installation angle)
A message is displayed, and projection stops automatically after about five minutes. Check the installation
angle of the projector.
• Check the guaranteed operating range.
s "Warning and Cautions on Installation" p.3
• Check if Direction in the Configuration menu is set correctly.
s "Setting the direction" p.28
Reading the Indicators
168