Indicator Cause Remedy or Status
Power Status Lamp Temp Filter
Blue -
Flashing
Status
varies
Status
varies
Status
varies
Orange -
On
Low Air Flow This is not an error. However, projection stops automatically if the airflow falls any further.
"The air filter is clogged. Clean or replace the air filter."is displayed. Check the following points.
• Check that the air filter and air exhaust vents are clear, and that the projector is not positioned against a
wall.
• If the air filter is clogged, turn off the power, remove the power cord from the electrical outlet, and then
clean or replace them.
s "Cleaning the Air Filter" p.189
s "Replacing the Air Filter" p.195
If the error continues after checking the points above, stop using the projector, remove the power plug
from the electrical outlet, and contact your local dealer or the nearest address provided in the Epson
Projector Contact List.
s Epson Projector Contact List
Status
varies
Status
varies
Status
varies
Status
varies
Orange -
Flashing
Air Filter Notice "Time to clean the air filter. Clean or replace the air filter."is displayed.
Turn off the projector's power, unplug the power cord from the electrical outlet, and then clean the air
filter.
s "Cleaning the Air Filter" p.189
The indicators or messages regarding air filter notice are displayed only when Air Filter Notice is set to On
in the Configuration menu.
s Extended - Display - Air Filter Notice p.140
a
• See the following if the projector is not operating properly, even though the indicators are all showing normal.
s "Problem Solving" p.177
• If the indicators are in a state not shown in this table, stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or
the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Reading the Indicators
169
To Next Page
Loading...
