Submenu Function
Brightness Set-
tings
Light Source Mode: Set the brightness for the light source.
• Normal: Select this if you do not want to decrease the
brightness. This makes the light source operation time
approximately 20,000 hours.
• Medium: Noise from the fan is louder than when Quiet is
selected, but it does not decrease the brightness as much.
This sets the brightness at 85%. This makes the light
source operation time approximately 20,000 hours.
• Quiet: Select this if you are concerned about the noise
made by the fan. This sets the brightness at 70%. This
makes the light source operation time approximately
20,000 hours.
• Extended: Select this to extend the life expectancy of the
light source. This sets the brightness at 70%. This makes
the light source operation time approximately 30,000
hours.
• Custom: Select this to set the brightness level within a
range of 30 to 100%.
Brightness Level: (Only available when Light Source Mode
is set to Custom) Sets the brightness for the light source.
Constant Brightness: (Only available when Light Source
Mode is set to Custom) When set to On, the brightness of
the light source set in Brightness Level is maintained as it
is. When Constant Brightness is set to On, you cannot
change the settings for Light Source Mode and Brightness
Level.
s "Setting the Brightness" p.77
Estimated Remains: When Constant Brightness is set to
On, this indicates the amount of time for which constant
brightness can be maintained.
s "Guide to Estimated Remains" p.78
Submenu Function
Remote Receiv-
er
You can limit the reception of the operation signal from the
remote control.
When set to Off, you cannot perform any operations from
the remote control. If you want to make operations from
the remote control, hold down the [Menu] button on the
remote control for at least 15 seconds to reset the setting to
its default value.
User Button
Select the items in the Configuration menu that you want to
assign to the [User1], [User2], and [User3] buttons on the
remote control. The following items can be assigned.
Light Source Mode, Multi-Projection, Resolution, On-
Screen Display, Display the QR Code, Image
Enhancement, Frame Interpolation, Link Menu, Content
Playback, USB
(USB is only enabled when Content Playback is set to
On.)
Test Pattern
You can display a test pattern to adjust the projection
without connecting other equipment when you set up the
projector.
s
"Displaying the Test Pattern" p.33
Memory
Perform operations and make settings for the memory
function.
s "Memory Function" p.110
Content Play-
back
Content Playback: When this is set to On, you can play
playlists created in Epson Projector Content Manager.
Overlay Effect
*
: Adds color and shape decorations to the
image. (This is only enabled when Content Playback is set
to On.)
USB Viewer: Plays playlists stored on a USB flash device.
(This is only enabled when Content Playback is set to
On.)
List of Functions
145
To Next Page
Loading...
