Submenu Function
Verify Server Cert.: Set to On to perform verification for
the certificate of the certification server. To verify a server
certificate, you need to set CA certificate.
CA certificate: Imports CA certificates for use in PEAP,
PEAP-TLS, EAP-TLS, and EAP-FAST.
RADIUS Serv.Name: Specify the name of the certification
server. You can enter up to 32 single-byte alphanumeric
characters.
Channel
You can select the channels used to connect in Quick mode.
If interference from other signals occurs, use a different
channel.
IP Settings
*
Perform network settings.
DHCP: Set to On to configure the network using
DHCP
g
.
If this is set to On, you cannot set any more addresses.
IP Address: You can enter the
IP address
g
assigned to the
projector. You can enter a number from 0 to 255 in each
field of the address. However, the following IP addresses
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask: You can enter the
Subnet Mask
g
for the
projector. You can enter a number from 0 to 255 in each
field of the address. However, the following subnet masks
cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can enter the IP address for the
gateway for the projector. You can enter a number from 0
to 255 in each field of the address. However, the following
Gateway Address
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
SSID Display
To prevent the SSID from being displayed on the LAN
Standby screen, set this to Off.
IP Address Dis-
play
To prevent the IP address from being displayed on the LAN
Standby screen, set this to Off.
Submenu Function
IPv6 Settings
Perform settings to use the IPv6 protocols.
a
• The following functions support IPv6
protocols.
- Epson Web Control
- PJLink
• When setting the IPv6 address manually,
make settings in Advanced from Epson
Web Control.
s "Changing Settings Using a Web
Browser (Epson Web Control)" p.218
IPv6: Set this to On when using IPv6 protocols. Make sure
one link local address is set when using IPv6. This is
composed of the interface ID created from fe80:: and the
projector's MAC address.
Auto Configuration: Set this to On to automatically acquire
an IPv6 address from RA (Router Advertisement). The
address is composed as shown below.
• Stateless Address (0 to 6): Created automatically by
combining the prefix acquired from the RA (Router
Advertisement) and the interface ID created from the
projector's MAC address.
• Stateful Address (0 to 1): Created automatically from the
DHCP server using DHCPv6.
Use Temporary Address: Set this to On to temporarily
validate the IPv6 address (0 to 1) when Auto Configuration
is On.
* This can be selected only when Connection Mode is set to Advanced.
Type of security
When the optional wireless LAN unit is attached and being used in
Advanced connection mode, it is strongly recommended that you set
security.
List of Functions
160
To Next Page
Loading...
