Submenu Function
Projection
Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [Shutter] button for about five seconds.
FrontWFront/Ceiling
RearWRear/Ceiling
Submenu Function
Operation
Direct Power On: Set to On to turn on the projector
simply by supplying power.
When the power cord is plugged in and the main power
switch is turned on, note that the projector turns on
automatically in cases such as a power outage being
restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
High Altitude Mode: Set to On when using the projector
above an altitude of 1,500 m.
Startup Source Search: Set to On to automatically detect an
image signal from another source and project the image
when there is no image signal from the current source.
Auto Power On: If it is set to Computer or BNC, the
projector is turned on when the signals are received from
the Computer port or BNC port, even when the projector is
in standby status.
Shutter Settings: Make settings related to the shutter.
• Fade-in: Specify the number of seconds for fade-in when
displaying an image.
• Fade-out: Specify the number of seconds for fade-out
when hiding an image.
• Shutter Timer: When it is set to On, if no operations are
performed for about 2 hours after shutter is activated, the
projector turns off automatically.
• Shutter Release: If it is set to Shutter, it is only released
by pressing the Shutter Button (or by sending an off
command to set the [Shutter] to off).
When set to Any Button, the shutter function is released
when any operation is performed on the projector.
List of Functions
126
To Next Page
Loading...
