c
While holding down the [Menu] button, turn on the main power
switch.
When the projector's indicators turn on as follows, release
the [Menu] button.
Power supply Status Laser Temp
Blue - On Blue - On Orange - On Orange - On
The indicators remain on for about 75 seconds.
When all of the indicators start flashing, the settings are being
written.
Caution
• Do not disconnect the power cord from the projector or turn off the
main power switch while the settings are being written. If power is not
being supplied, the projector may not startup correctly.
• Do not disconnect the USB flash drive from the projector while the
settings are being written. If the USB flash drive is disconnected, the
projector may not start correctly.
d
When writing completes normally, the projector enters standby
status.
Power supply
Blue - On
When the projector is in standby status, remove the USB flash
drive.
Batch Setup
141
To Next Page
Loading...
