Combining multiple projected images
(1) Set the arrangement of the images.
s "Performing tiling automatically" p.85
(2) Adjust the edges of the images
s "Edge Blending" p.87
s "Black Level" p.88
(3) Unify the brightness and tint of the images
s "Screen Matching" p.92
(4) Splice the images to create one, large image
s "Displaying a Scaled Image" p.95
Adjusting manually offline
Adjust the images from all projectors manually.
Advance preparation
Set an ID for all projectors and the remote controls.
s "Set the projector ID" p.37
Adjusting projected images individually
(1) Unify the aspect ratio and size of the image
s "Screen Settings" p.28
s "Changing the Aspect Ratio of the Projected Image " p.71
s
"Adjusting the Image Size" p.33
(2) Adjust the orientation and position of the image
s "Installation Settings" p.27
s "Adjusting the Position of the Projected Image (Lens Shift)" p.31
(3) Fine tune the focus and distortion of the image
s "Correcting the Focus" p.34
s "Point Correction" p.65
Combining multiple projected images
(1) Set the arrangement of the images.
s "Performing tiling manually" p.86
(2) Adjust the edges of the images
s "Edge Blending" p.87
s "Black Level" p.88
(3) Unify the brightness and tint of the images
s "Color Matching" p.94
(4) Splice the images to create one, large image
s "Displaying a Scaled Image" p.95
Tiling
Set the arrangement for each projector when lining up and projecting from
multiple projectors.
a
Before performing tiling, adjust the projected image so that it is a
rectangle. Also, adjust the size and focus of the images.
s
"Adjusting the Image Size" p.33
s "Correcting the Focus" p.34
Multi-Projection Function
84
To Next Page
Loading...
