Automatically Detecting Input Signals and
Changing the Projected Image (Source Search)
Press the [Search] button on the remote control to project images from the
port currently receiving an image.
When two or more image sources are connected, repeatedly press
the [Search] button until the target image is projected.
When your video equipment is connected, start playback before beginning
this operation.
a
• You can make settings so that images are projected from the same
input port the next time the projector is turned on.
s Extended - Operation - Startup Source Search p.125
• The following screen is displayed while no image signals are input.
Projecting Images
53
To Next Page
Loading...
Need help?
General