Epson EB-L530U - Supported Features for the Epson Projector Professional Tool

Supported Features for the Epson Projector Professional Tool
258
Your projector supports the following features and options for the Epson
Projector Professional Tool software.
a
• The Epson Projector Professional Tool software does not support
multiple projector connected in a chain using HDMI Out Setting in
the projector's Multi-Projection menu and the HDMI Out ports.
• If you change the Screen Type and Screen Position settings, the
Geometry Correction settings are reset.
• If you want to turn on the projector through the HDBaseT
transmitter, set the A/V Output setting to Always On in the
projector's Signal I/O menu.
Features/Options EB‑L735U/EB‑L730
U/EB‑L720U/EB‑L6
35SU/EB‑L630SU/E
B‑L630U/EB‑L530U
/EB‑L520U
Camera Assist
features
-
Layout/Monitorin
g tab
Input Voltage
-
Setting tab Lens Control tab -
Initial Setting >
Basic 3 tab
Startup
(Shutter)/Standby
(Shutter)
-
Fade-in
(seconds)/Fade-out
(seconds)
-
Shutter Timer You can set this as
the projector's A/V
Mute Timer
setting.
Standby
Confirmation
-
Features/Options EB‑L735U/EB‑L730
U/EB‑L720U/EB‑L6
35SU/EB‑L630SU/E
B‑L630U/EB‑L530U
/EB‑L520U
Reset All Config The following
settings are also
reset:
• Color
Uniformity
• Color Matching
Reset Screen
Matching
Only the following
settings are reset:
• Color
Uniformity
• Color Matching
Geometry
Correction tab
Curved Surface
-
Corner Wall -
Marker display
when dragging and
dropping a point
-
Adjustments
outside the
projection area
-
An absolute
coordinate value
and a relative
coordinate value
✓
General menu Geometry
Correction File
-
Projector File -