173
off by shutting off the power outlet. Set Light Source Calibration events to occur only after 100 hours of
usage.
1. Set the date and time in the Date & Time menu.
2. Press the Menu button.
3. Select the Extended menu and press Enter.
4. Select the Schedule Settings setting and press Enter.
5. Select the Schedule menu and press Enter.
6. Select Add New and press Enter.
You see a screen like this:
7. In the Event Settings section, select the events you want to have occur. (Select No Change for
events that you do not want to occur.)
8. In the Date/Time Settings section, set the date and time for the scheduled events to occur.
9. When you are finished, select Save and press Enter.
10. To schedule more events, repeat the previous steps as necessary.
11. Select Setup complete and select Yes to save your changes.
To Next Page
Loading...
