Epson EB-PU2116B - EAP Method; Channel; IP Settings

Network Menu
110
a
• You can enter up to 32 characters in the projector's menu. To enter
more than 32 characters, use your Web browser.
• When Connection Mode is set to Quick, the initial passphrase is set.
EAP Method
s Network > Network Configuration > Wireless LAN > EAP Method
You can set the EAP settings for WPA3-EAP and WPA2/WPA3-EAP
security.
EAP Type
Select the protocol for authentication.
PEAP
Authentication protocol widely used in Windows Server.
PEAP-TLS
Authentication protocol used in Windows Server. Select this when
using a client certificate.
EAP-TLS
Authentication protocol widely used to use a client certificate.
EAP-FAST
Select this when these authentication protocols are used.
User name
Enter a user name for the network up to 64 alphanumeric characters long.
To include a domain name, add it before the backslash and the user name
(domain\username).
When importing a client certificate, the name the certificate was issued to
is automatically set.
Password
Enter a password for authentication up to 64 alphanumeric characters
long. After you enter the password and select Finish, the password is
displayed as an asterisk (*).
Client Certificate
Import the client certificate.
Verify Server Certificate
You can verify the server certificate when a CA certificate has been set.
CA certificate
Imports the CA certificate.
RADIUS Server Name
Enter the server name to verify up to 32 alphanumeric characters long.
a
• You can enter up to 32 alphanumeric characters long in the projector
menu. To enter more than 32 characters, use your Web browser.
• Password is only displayed when EAP Type is set to PEAP or EAP-
FAST.
• Client Certificate is only displayed when EAP Type is set to PEAP-
TLS or EAP-TLS.
Channel
s Network > Network Configuration > Wireless LAN > Channel
Set the frequency band (channel) using in Quick connection mode.
If interference from other signals occurs, use a different channel.
IP Settings
s Network > Network Configuration > Wireless LAN > IP Settings
s Network > Network Configuration > Wired LAN > IP Settings
Set DHCP to On if your network assigns addresses automatically.
Set to Off to manually enter the network's IP Address, Subnet Mask, and
Gateway Address using 0 to 255 for each address field.
Do not use these addresses:
• for the IP Address: 0.0.0.0, 127.x.x.x, 192.0.2.x, or 224.0.0.0 through
255.255.255.255
• for the Subnet Mask: 255.255.255.255 or 0.0.0.0 through 254.255.255.255