Epson EB-W16SK - Page 14

1414141414
Superimposing the
images from the
commander and the
receiver
Superimpose two
images. Perform after
setting up.
Projecting
Images
Press the [ ] button on the
commander's control panel.
The commander and the receiver
turn on.
Hold down the [Screen Fit]button
for about ve seconds.
The adjustment top screen is
displayed.
A
Open the A/V mute
slides.
Open the A/V mute slides on the
commander and the receiver.
B
Turn on the projectors.
C
Display the screen
to adjust the
superimposed images.
Receiver frame
(green)
Commander frame
(white)
■
Superimposing Images
When suspending the
projectors from a
ceiling, change the
Projection mode before
superimposing the images.
You can change the
Projection mode by
holding down the [A/V
Mute] button on the
remote control for about
ve seconds.
Adjusting the Focus
Match the focus for the commander and the receiver.
Determining the size of the receiver's frame
Adjust the receiver's projection size to fit the screen.
Surrounding the receiver's frame with the
commander's frame
Adjust the commander's frame (white) so that it is outside the
receiver's frame (green).
The screens t together.
Approx.
ve seconds
• Pressing buttons on the control panel operates the
commander and the receiver. Perform projector
operations from the commander's control panel.
• The following icon is displayed when turning on. The
projector indicated by the arrow is the subject of the
displayed message.
Commander
Receiver