Epson EB-W51 - EX Duct (Assy)

EB-E01 series Disassembly and Assembly INTERNAL USE ONLY
SEIKO EPSON 118 Revision A
3.3.12 EX Duct (Assy)
DISASSEMBLY PROCEDURE
1. See Flowchart (p70) and remove all parts up to the component below from
the projector.
Optical Engine (Assy) (p113)
2. Remove the two screws ( ) and the screw ( ), remove the Thermostat of
the "Cable PS-FB" and then remove the "EX Duct (Assy)".
At the area shown below, an electric shock may result if you operate
carelessly because there is electric charge remaining in the Power
Supply. 3.3.14 PS Ballast Assy (p122)
Pass the cable through the "EX Duct (Assy)" and set the
thermostat of the "Cable PS-FB" such that the surface
with the letters is visible from top to bottom.
EX Duct (Assy)
PS Ballast Assy
C.C.P-TITE SCREW,3X10,F/ZN-3C
C.B.P-TITE SCREW,2.5X10,F/ZN-3C