EB-E01 series Disassembly and Assembly INTERNAL USE ONLY
SEIKO EPSON 119 Revision A
3.3.12.1 EX Fan/TH Board
DISASSEMBLY PROCEDURE
1. See Flowchart (p70) and remove all parts up to the component below from
the projector.
EX Duct (Assy) (p118)
2. Remove the screw ( ) and remove the "TH Board" and the "TH Cable
H838".
3. Remove the two screws ( ) and remove the "Upper EX Duct".
4. Remove the following parts from the "Lower EX Duct".
EX Plate
EX Fan
EX Fan Cushion A x2 pcs
EX Fan Cushion B
Route the cable on the EX Duct as shown in the figure below.
The cables should not be stranded by the hooks.
Twist the cables thrice clockwise and route them so that
they do not affect this part.
Let them loose inside the yellow
dotted line. Do not pull the cables.
TH Board
TH Cable H838
Upper EX Duct
EX Fan Cushion A
EX Plate
EX Fan Cushion B
EX Fan
Lower EX Duct
C.B.P-TITE SCREW,2.5X10,F/ZN-3C
To Next Page
Loading...