EB-E01 series Troubleshooting INTERNAL USE ONLY
SEIKO EPSON 42 Revision A
Lamp: Lamp Error
Lamp On: Lamp Lit Error
Lamp Off: Lamp Failure
Take out the lamp and check if
the Lamp is cracked or
damaged.
If the Lamp is cracked/
damaged,
replace it with a new one.
P.43
Air Filter condition
(dirt accumulation, clogging)
If clogging is found, clean or
replace the Air Filter.
If the projector has been used at
a place where is 1500 meters or
higher above sea level:
If the High altitude mode is
ON, set it to OFF.
After trying above remedies:
If the same error occurs after
turning the power back on,
check the error name and carry
out the remedy referring to the
references on the right column.
LED Status
Corresponding error name Remedy Reference
Power Status Lamp
Temp
Wireless LAN
To Next Page
Loading...